http://www.intersoftsolutions.com/Community/WebGrid/Issue-in-Deploying-NET-code-with-Webgrid-6-on-Webserver/http://www.intersoftsolutions.comenCopyright 2002 - 2015 Intersoft Solutions Corp. All rights reserved.60http://www.intersoftsolutions.com/Community/WebGrid/Issue-in-Deploying-NET-code-with-Webgrid-6-on-Webserver/Fri, 03 Jun 2011 04:21:08 GMTRiendyDeploy.Net 3.5<p>Hi Udaya,</p><p>Your question has been answered in your other <a href="http://intersoftpt.com/Community/WebGrid/Do-we-need-to-install-Webgrid-6-Assembly-on-the-Webserver/" target="_blank">thread</a>. Would you please take a look at that page and let me know if you still get any trouble there.</p> <p><br /></p> <p>Thank you.<br />Riendy</p>http://www.intersoftsolutions.com/Community/WebGrid/Issue-in-Deploying-NET-code-with-Webgrid-6-on-Webserver/Wed, 01 Jun 2011 01:15:28 GMTudayabhaskar_kDeploy.Net 3.5<p>Hi,</p> <p>I have upgraded from my application from .NET 1.1 framework to .NET 3.5 framework, because of which I had to upgrade Webgrid from 3.0 version to 6.0 version.  While migrating the application to .NET 3.5 framework, we encountered problems wherever Webgrid 3.0 was being used giving the error as below:</p> <p> </p> <p><strong>Error Message: </strong>Attempted to read or write protected memory. This is often an indication that other memory is corrupt.</p> <p> </p> <p>Once we upgraded Webgrid from 3.0 to 6.0, we stopped getting these errors. Now, when we deploy the same code on the webserver,  we are again getting the same error message though we placed all the DLLs in the correct location. </p> <p> </p> <p>Kindly need some help on the issue above urgently.</p>